Gallery
About Us
My Account
Language
English
中文
SHOP ONLINE
Product Guide>>
IR Camera
StrobeFlash Camera
IR Booster
SolarPower Cam
Accessory
More
Contact
Download
Support
Account
Register
Frequency Answers & Questions
IRX-22BW
:
Troubleshooting Guide:
BAT-CHECK LED on booster did not Light up by pushing the Bat-Check button when PW is either at ON or TEST mode, but it would light up while PW is at OFF :
Battery is going dead almostly. When a loading is activated, those batteries did not work. You must install a new set batteries now.
I could observe the Self-Test Indicator on Booster does ON during pressing TEST /BAT-LOW button on transmitter under TEST mode, but I found camera always take dark images or videos and the Self-Test Light did not turn ON when camera was taking night video or picture:
Check if the gooseneck sensor was already away from the IR light source on camera. Most of cases were caused by the IR sensor did not snap on properly or falling down from camera. This issue would cause the IR sensor was shifted after you left. Therefore, you have to find a way to make it snapping firmly. Another reason might be the current environment still bright that the camera does not switch ON the internal IR light source during a transition time of day /night. Also, booster and transmitter will only work at night only. So, either one might still detect a day time period, the booster system will not work at this moment until to an environment become dark completely.
Seems not too much help even this booster was in-used:
Investigate for a possible issue if a current angle of booster might not the same as the camera lens. Need to adjust an angle on each booster with the skill explained on Preparation Chapter above. In other case, you try to move the booster near to camera to make them in the same target zone. In order to get the best result, you have to take a several night images with the booster in difference angles and locations. Of course you need to prove the batteries are not poor before you try to do further testing. In case a zone is very large and a target will be always far away, you may consider to add one or more IR boosters to get greater illumination.
Seems the brightness for most of pictures and videos to be darker than comparing with using internal visible RED Glow IR light:
Usually, it is correct due to the efficiency of a CMOS camera sensor against visible IR length-wave is much higher than invisible IR length-wave. So, if you expect to get more brightness on images or videos, you can check firstly if both boosters and camera are toward for a same target zone. Then, you may consider to add more black IR boosters to improve.
I noticed some of Slave will be always switched ON even camera did not work:
the setting of trigger source option on each slave, improper connection in a chain will cause such problem. All boosters which in a chain connecting to the IR-Out on the MASTER (The first booster controlling by transmitter) must be required to set SLAVE /CABLE mode. Refer to the wired booster manual description.
A scroll bar always appear in every night videos. Sometimes scrolls fast sometimes slow:
You need to refer the Advanced Usage Setting of this manual to eliminate a scrolling bar after adjustment.
I am sure my IR camera does work at night, but the booster did not work:
At the first, check the coding of the system. 2nd, resume the procedures to test the system under the Self-test mode.
During setting up my scouting system, I could see the Distant-Test Light to be ON while pressing the Bat-Low Check button on booster, but it did not response while I press the BAT-CHECK key on transmitter:
You need to check if the Main PW switch is at TEST mode firstly, also, the transmitter and the booster must be required with a same security code in order to work in the same work group. Check the Transmit light on transmitter while pressing.
Need
Support?
More FAQ for Other Models