Gallery
About Us
My Account
Language
English
中文
SHOP ONLINE
Product Guide>>
IR Camera
StrobeFlash Camera
IR Booster
SolarPower Cam
Accessory
More
Contact
Download
Support
Account
Register
Frequency Answers & Questions
AC-833s
:
Troubleshooting Guide:
No animal showing in some pictures:
1. Check if the unit is pointed the direction where the sun is rising or sunset that the sensor might be triggered
2. The PIR sensor may detect an animals through vegetation out of view from the camera.
The Camera In-Use light is remaining ON, but the camera does not respond:
1. The camera may be time-out and shut down automatically. Repeat to press the CAM-PW to resume the camera ON.
2. Battery may be too low that could not support the camera staying ON. Replace with 4pcs D type brand new batteries.
Camera seems NOT write any picture into my “Empty SD” card and displayed with Memory Full:
1. You must format the SD card which was ever used in the other device before applying it in this camera.
2. Check the current SD card and try to use a brand New SD card instead of your current SD.
Sometimes I could not get pictures and videos at night, but it was working fine at day times:
It is because the battery set for camera +IR light was too weak that could not work at night.
I have set Time lapse Enable in camera setting, but it seems it is not working:
1. You need to push the Trigger Time switch to TIME-LAPSE (Fast mode).
2. Before you will leave, you need to trigger for the 1st shot by yourself.
3. To view your time-lapse images, just press the RIGHT key after entered to PREVIEW mode, you will see the last shot of Time-Lapse. Then, press the left key to view the previous Time-Lapse shots.
4. To create your Time-lapse video, you have to use any Time-lapse software to assist. You can consult your dealer or download one of popular one from web.
I have set the shot mode for PICTURE already from AVI, but it worked improperly:
You need to always reboot the unit by power OFF and back ON after changed for either mode.
Can I just install a part of battery set like D cells or C cells only in case I will connect a solar power pack?
Not be recommended. Need to install full sets batteries for both compartments or just no battery.
Reset the Unit out of System Halt:
In case the event counter stop to respond for any sensing, or you notice the LCD is always blank even the Power switch is ON, the system may halt already to cause the problem. Remove all batteries out of compartment for more than 10 minutes in order to reset the unit. All pictures will be retained and the unit will resume to the factory default settings. You will need to reprogram with your desired parameters before use.
How to upgrade or reload the FW to my camera?
Sometimes, you are recommended to upgrade the camera firmware to perform better functions. Or your camera FW was crashed by unknown reason to work improperly. What you can do will be a simple thing that you can reload the firmware into the camera. See more details from the
article related about your issue
. After done, reboot the camera to recover your camera for the factory default.
Need
Support?
More FAQ for Other Models