Gallery
About Us
My Account
Language
English
中文
SHOP ONLINE
Product Guide>>
IR Camera
StrobeFlash Camera
IR Booster
SolarPower Cam
Accessory
More
Contact
Download
Support
Account
Register
Frequency Answers & Questions
AC-856
:
Troubleshooting Guide:
No animal showing in some pictures:
1. Check if the unit is pointed the direction where the sun is rising or sunset that the sensor might be triggered
2. The PIR sensor may detect an animals through vegetation out of view from the camera.
3. If the animal was moving quickly, camera may not capture it in time while an animal moved out of the zone.
4. Make sure that the unit is mounted on a steady tree or other place that does not wobble.
Camera In-Use light was ON, but the camera did not respond/small light was remaining ON:
1. The camera may be time-out w/o any key-in and shut down automatically or Camera does hang up. Turn off Camera and back on after 5 seconds to resume the camera operation or try to reboot the system.
2. May be too many image files in the SD card, more files will cause a longer initializing times and camera will delay to respond your key in. You can remove all of the files to computer.
3. You attempt to back on again the camera instantly after just turn off camera. Usually, it is suggested to back on the camera after 5 seconds of a previous shut down event was done if you want to resume camera operation.
The Light in the front of the housing does remain ON:
1. The unit just is set for Walk-Test mode. The light still remains ON steady within 60s warming up period.
2. The CAM-PW is not switched to OFF. Remember to turn camera OFF after finished camera operation.
NOT write picture into my “Used SD” card and seems a capturing event was done as usual:
1. You must format the SD card which was ever used in the other device before applying it in this camera.
2. Check the current SD card and try to use a brand New SD card instead of your current SD.
Observed the Solar storage electric is full from level memter, but unit did not response:
A. Press and hold Solar PW for 2s to turn ON the solar power storage circuit.
B. Attempt to re-charge by a general Android smartphone charger.
Has slided the switch to Time-Lapse ON, but I still could not get any Time-Lapse images:
Check if the Time lapse function in the camer menu is enble. Don’t forget to program two important parameters after activate this function.
Why I could not review my last shot and saw other images seems from Time-Lapse?
Back on the camera and enter to preview mode, then, you are viewing the last shot from scouting mode. Press the LEFT key immediately to view other previous scounting shots. In case press the RIGHT key, you will view the last image of Time-Lapse. Only a way to scouting mode should be back on the camera.
Reset the Unit out of System Halt:
In case the event counter stop to respond for any sensing, or you notice the LCD is always blank even the Power switch is ON, the system may halt already to cause the problem. Remove all batteries out of compartment for more than 10 minutes in order to reset the unit. All pictures will be retained and the unit will resume to the factory default settings. You will need to reprogram with your desired parameters before use.
Need
Support?
More FAQ for Other Models