Gallery
About Us
My Account
Language
English
中文
SHOP ONLINE
Product Guide>>
IR Camera
StrobeFlash Camera
IR Booster
SolarPower Cam
Accessory
More
Contact
Download
Support
Account
Register
Frequency Answers & Questions
AC-821
:
Troubleshooting Guide:
No animal showing in some pictures:
1. Check if the unit is pointed the direction where the sun is rising or sunset that the sensor might be triggered.
2. The PIR sensor may detect an animals through vegetation out of view from the camera.
3. If the animal was moving quickly, camera may not capture it in time while an animal still staying in the zone.
4. Make sure that the unit is mounted on a steady tree or other place that does not wobble.
The Camera In-Use light is remaining ON, but the camera does not respond:
1. The camera may be time-out and shut down automatically. Repeat to press the CAM-PW to resume the camera ON.
2. Battery may be too low that could not support the camera staying ON. Replace with 4pcs D type brand new batteries.
The CAM-PW switch does not respond:
Attempt to turn the camera too quickly after the main power ON. Wait for about 10 seconds until the back light of scouting LCD goes to OFF. Then try again.
The Light in the front of the housing does remain ON:
1. The unit just is set for Walk-Test mode. The light remains On steady within 60s warming up period.
2. The CAM-PW is not OFF. Remember to turn camera OFF after finishing usage.
Camera seems NOT write any picture into my empty CF card and displayed with Memory Full:
1. You must format the CF card which was ever used in the other device before applying it in this camera.
2. Check the current CF card and try to use 1G CF card instead of your current CF which may larger than 2G or above. To use a large CF card over 1G, a specified brand may be required.
Reset the Unit out of System Halt:
In case the event counter stop to respond for any sensing, or you notice the LCD is always blank even the Power switch is ON, the system may halt already to cause the problem. Remove all batteries out of compartment for more than 10 minutes in order to reset the unit. All pictures will be retained and the unit will resume to the factory default settings. You will need to reprogram with your desired parameters before use.
Need
Support?
More FAQ for Other Models